区二区三区观看_男生和女生操逼软件_天天色影综合网_美女噜噜在线观看_欧美日韩色影院_AV网站手机在线观看_91人妻免费精品无码视频_曰本福利写真片视频在线_国产成人色按摩..久久_亚洲乱伦视频网

According to the actual situation on site, fine tune the various partitions of the window line to ensure aesthetics and consistency. The thickness of the thick plaster layer (starting from the upper surface of the board groove) should not exceed 30mm. The EPS board is filled with anti cracking mortar, and the gypsum layer is completely covered with steel mesh and board anchors, with anti cracking measures taken. The thick plaster layer should be applied several times and maintained under alternating dry and wet conditions. When it is necessary to reserve construction joints for crack resistant mortar, a stepped ramp should be used. Spray inside the corners and spray from the inner corners to both sides to reduce the accumulation of inner corners. After 15-20 minutes, gently press the burr formed on the inner corner with an iron plate to keep the inner corner straight. The details refer to the starting point of the spray.

1. Brush the horizontal line of the paintball shooting, then paste a 2cm wide beautification paper, and then spray real stone paint to remove the beautification paper.

2. Control point: When repairing, please ensure that the joint of the partition is on a horizontal surface and does not exceed the upper and lower horizontal lines.

The concrete for the wall should be poured in layers, with layer by layer pouring and layer by layer vibration, and the layer height should be controlled within 500mm. It is strictly prohibited to cut open the EPS board with the pump tube, and the vibrating rod must not come into contact with the EPS board. After removing the liner, twist the holes with dry cement mortar, seal the EPS board holes with similar materials, and the hole length should not be less than 50mm. For local unevenness on the surface of EPS boards, EPS granular insulation paste should be used for repair and leveling. The thickness of the repaired tablet should not exceed 10mm.

When pasting the insulation board, first apply a layer of glue on the insulation board. Then stick a layer of insulation adhesive board on the wall, press it evenly, and use a 2000mm ruler to check the flatness and verticality of the insulation board. Insulation boards should not collide with each other, and the upper and lower boards should be bonded together. At the corners of the wall, the insulation boards should be connected together; At the entrance and exit of doors and windows, the distance between the connection of the insulation board and the parallel edge of the doors and windows should be greater than 200 millimeters.

Non flammable, fire-resistant characteristics: high temperature calcination above 1200 ° C, combustion performance A1. The refractory bricks and refractory materials of thermal power plants are ideal materials for external insulation systems and fire barriers with fire prevention requirements. The insulation board has the characteristics of fire resistance, flame retardancy, small deformation coefficient, aging resistance, stable performance, environmental protection, good compatibility with wall base and plaster layer, safety and stability, and the same service life as buildings. The specifications used are generally 123mm × 600mm × 90mm; The commonly used specifications for rock wool board are 600mm × 600mm × 130mm. There shall be no less than 6 anchorages per square meter, usually 1 per corner and 2 in the middle. For panels less than 4 millimeters wide, an anchor point should be provided at each corner; For wide panels ranging from 400mm to 800mm, an anchor point should be placed at each corner and a middle anchor point.